TRICONEX 3006

Description

Manufacturer : Triconex

Product No. : 3006

Product type : Main processor

Main processor : Motorola MPC860, 32-bit, 50 MHz

Memory : 16 MB DRAM (without battery back-up), 32 KB SRAM (with battery back-up), 6 MB Flash PROM

TriClock : Time and date, Battery back-up, Typical drift: ±2 seconds/day, Maximum drift: ±2.16 seconds/day

TriBus : 25 megabits/second, 32-bit CRC-protected, 32-bit DMA, fully isolated

Serial port : For diagread diagnostic analysis, Optically isolated RS-232 interface on one 25-pin connector, 500 VDC isolation

Communication processor : Motorola MPC860, 50 MHz, 32-bit

Shipping Weight : 3 Kg
After arriving at the site and before installing the system, it is necessary to consider whether the installation environment meets the requirements of the use environment of PLC, which can be referred to the user manual of various products. However, no PLC can be installed in the following places: places containing corrosive gases, places directly exposed to sunlight, places where the temperature changes rapidly in a short time, places where oil, water and chemicals are easy to invade, places where there is a lot of dust, places where vibration is large and will cause displacement of the installation parts.

If it is necessary to use in the above environment, appropriate control box shall be made for PLC, and standard and necessary protective measures shall be adopted. If you need to use it in the field at extremely low temperature, you can use the control box with heating function. How to make these protective boxes or control boxes, manufacturers and qualified system integrators will provide customers with corresponding supply and design.

When using the control box, pay attention to the following items when installing the OpenPLC in the control box: whether the air flow in the control box is smooth (proper distance must be maintained between the devices), whether the transformer, motor controller, frequency converter, etc. are kept at a proper distance from the PLC, whether the power line and signal control line are separately configured, whether the installation position of the components is convenient for future maintenance, and whether space needs to be reserved for future system expansion.