Vibro-meter VM600 CPUM

Description

Vibro-meter VM600 CPUM
Discrete signal interface (DSI) inputs
Control signal
• Alarm reset (AR) : A closed contact between the DSI AR and DSI RET inputs resets
(clears) the alarms latched by the MPC4/IOC4T card pair.
Note: The alarm reset input (DSI AR) is edge-sensitive and a high-tolow transition is required to activate the reset.
• Danger bypass (DB) : A closed contact between the DSI DB and DSI RET inputs inhibits
(bypasses) the danger relay outputs
• Trip multiply (TM) : A closed contact between the DSI TM and DSI RET inputs multiplies
the alarm levels by a scale factor (software configurable), to
enable adaptive monitoring.
Operating principle : Detection of an open circuit or a closed circuit on the input
Alarm outputs
Alarm relays : 4 per IOC4T card.
The MPC4 card can drive the four local relays on the IOC4T card,
as well the relays on RLC16 relay cards and/or IRC4 intelligent relay
cards using the VM600 rack’s Raw bus or Open Collector (OC) bus.
For IOC4T card relay features, see Relay characteristics on page 4.
For further information on RLC16 or IRC4 relay cards, refer to the
corresponding data sheet.

Analog (DC) outputs
Number of outputs : 4 per IOC4T card (one per MPC4 dynamic signal channel)
Signal range : Current output (4 to 20 mA) or voltage output (0 to 10 V),
individually selectable by a jumper on the IOC4T for each output.
Note: For current outputs, the analog output is actually driven in a
slightly wider 2 to 23 mA range, proportional to the input signal.
Accuracy : ≤±1.5%
Linearity error : ≤±0.5%
Admissible load on output : >100 kΩ for voltage output.
<325 Ω for current output. Relay characteristics Relay names : RL1 to RL4 Type : PE014005 Contact arrangement : 1 x NC or 1 x NO contact per relay (user configurable). The selected contacts are available on J2. Nominal rated voltage : 250 VAC Nominal rated current : 5 AAC Maximum breaking capacity (without contact protection) : 1250 VA