TEGAM 2350 modular

TEGAM 2350
The Models 2340/2350 are designed
for applications that require highvoltage amplification beyond the
standard voltage limitations of
most waveform, function, or pulse
generators.
With a maximum output voltage
of 400 Vp-p, the Models 2340/2350
come standard with a fixed gain
of +50. Gains from 10 to 100 are
available by special order.
Each channel is rated for 40 mA
continuous current with 0.2 Ω output
impedance. Each channel has an
independent, buffered, voltage
monitor output for applications that
require a low-level representation
of the output signal. The buffers
produce a reduction of 200:1 for
50 Ω inputs and 100:1 for 1 MΩ and
above inputs.
The output current is sensed in
both directions by the current limit
function. This provides maximum
protection to the amplifier during
operation. A built-in power supply
monitor protects the power
amplifiers by tracking the DC power
supply. If a high-voltage DC fault
occurs, the monitor will disconnect
the power supply from the power
amplifiers. Cycling the supply power
resets the fault. The amplifiers can
drive capacitive loads up to 200
pF while maintaining a full power
bandwidth exceeding 200 kHz.
For maximum user safety, the outputs
are grounded to the instrument
chassis to prevent accidental
voltage loops. A binding post is
provided on the front panel for a
direct chassis ground connection.
The Models 2340/2350 are costeffective solutions for specialized
applications where low distortion
and precise signal amplification is
required. These units are particularly
suited for high frequency,
electrostatic applications that
require high voltage.