BENTLY 3500/22M 138607-01

Description

BENTLY 3500/22M 138607-01
The 3500/22M Transient Data Interface (TDI) is the interface
between the 3500 monitoring system and compatible
software (System 1 Condition Monitoring and Diagnostic
software and 3500 System Configuration software). The TDI
combines the function of a 3500/20 Rack Interface Module
(RIM) with the data collection capability of a communication
processor such as TDXnet.
The TDI resides in the slot adjacent to the power supplies of a
3500 rack. It interfaces with M series monitors (3500/40M,
3500/42M, etc.) to continuously collect steady state and
transient dynamic (waveform) data and pass this data
through an Ethernet link to the host software. Refer to the
Compatibility section at the end of this document for more
information.
Static data capture capability is standard with the TDI.
However, using an optional Channel Enabling Disk will allow
the TDI to capture dynamic and high-resolution transient
data as well. The TDI incorporates the communication
processor function within the 3500 rack.
Although the TDI provides certain functions common to the
entire rack, it is not part of the critical monitoring path and
has no effect on the proper, normal operation of the overall
monitor system for automatic machinery protection. Every
3500 rack requires one TDI or RIM, which always occupies Slot 1
(next to the power supplies).

Front Panel
Rack reset
button
Clears latched alarms and
Timed OK Channel Defeat in
the rack. Performs same
function as “Rack Reset”
contact on I/O module
Address
switch
Used to set the rack address:
127 possible addresses
Configuration
Keylock
Used to place 3500 rack in
either “RUN” mode or
“PROGRAM” mode. RUN mode
allows for normal operation of
the rack and locks out
configuration changes.
PROGRAM mode allows for
normal operation of the rack
and also allows for local or
remote rack configuration.
The key can be removed from
the rack in either position,
allowing the switch to remain
in either the RUN or PROGRAM
position. Locking the switch in
the RUN position allows you to
restrict unauthorized rack
reconfiguration. Locking the
switch in PROGRAM position
allows remote reconfiguration
of a rack at any time.