GE IC697CPM925 CPU

GE IC697CPM925 CPU
Operation, Protection, and Module Status
Operation of this module can be controlled by the
three-position RUN/STOP switch or remotely by an
attached programmer and programming software.
Program and configuration data can be locked through
software passwords or manually by the memory protect
keyswitch. When the key is in the protected position,
program and configuration data can only be changed by
a programmer connected parallel only (to the Bus
Transmitter module). The status of a CPU is indicated
by the four green LEDs on the front of the module.
The CPM 925 requires forced air cooling for proper
operation in ambient temperatures greater than 40C
(104F). A fan capable of 70 CFM (including filters)
should be located beneath slot 1 of the rack containing
the CPU.
Fan assemblies (IC697ACC721, IC697ACC724, and
IC697ACC744) can be ordered for direct mounting on
the IC697 rack. Refer to the applicable Programmable
Controller Installation Manual for detailed information.
Installation
It is the responsibility of the OEM, system integrator, or
end user to properly install the PLC equipment for safe
and reliable operation. Product manuals provide
GE IC697CPM925 CPU
detailed information about installation, startup, and
proper use of the PLC equipment. The installation
manual, shipped with your PLC programming software,
describes how to properly install the equipment. If the
PLC installation must comply with supported standards,
such as FCC or CE Directives, please refer to the
Installation Requirements for Conformance to Standards,
shipped with the PLC programming software, for
additional guidelines.