GE PQMII-T20

Description

The GE Multilin PQMII Power Quality Meter is an ideal choice for continuous monitoring of a
single or three-phase system. It provides metering for current, voltage, real power, reactive
power, apparent power, energy use, cost of power, power factor, and frequency.
Programmable setpoints and four assignable output relays allow control functions to be
added for specific applications. This includes basic alarm on over/under current or voltage,
unbalance, demand-based load shedding, and capacitor power factor correction control.
More complex control is possible using the four switch inputs; these can also be used for
status information such as breaker open/closed and flow information.
As a data gathering device for plant automation systems that integrate process,
instrument, and electrical requirements, all monitored values are available via one of two
RS485 communication ports running the Modbus protocol. If analog values are required
for direct interface to a PLC, any of the monitored values can output as a 4 to 20 mA (or 0
to 1 mA) signal to replace up to four (4) separate transducers. A third RS232
communication port connects to a PC from the front panel for simultaneous access of
information by other plant personnel.
With increasing use of electronic loads such as computers, ballasts, and variable
frequency drives, the quality of the power system is important. With the harmonic analysis
option, any phase current or voltage can be displayed and the harmonic content
calculated. Knowledge of the harmonic distribution allows action to be taken to prevent
overheated transformers, motors, capacitors, neutral wires, and nuisance breaker trips.
Redistribution of system loading can also be determined. The PQMII can also provide
waveform and data printouts to assist in problem diagnosis.
Monitoring: A, V, VA, W, var, kWh, kvarh, kVAh, PF, Hz
• Demand metering: W, var, A, VA
• Setpoints for alarm or control from most measured values, including: unbalance,
frequency, power factor, voltage, and current
• four (4) output relays / four (4) switch inputs for flexible control configuration
• four (4) isolated analog outputs replace transducers for PLC interface
• one 4 to 20 mA analog input
• Modbus communications
• Three COM ports (two rear RS485 ports and one front RS232 port) for access by
process, electrical, maintenance, and instrument personnel
• Harmonic analysis for power quality review and problem correction
• 40-character display and keypad for local programming
• No-charge EnerVista PQMII Setup Software
• Simulation mode for testing and training
• Compact design for panel mount
• AC/DC control power