GE VMIVME-2128

Description

GE VMIVME-2128
128 bits of high-voltage outputs
• High-current drivers (600 mA sink)
• Automatic surge current shutdown protection
• Thermal shutdown protection
• High breakdown voltage (55 V)
• Output clamp diodes for inductive flyback protection
• Compatible with Intelligent I/O Controllers
• Built-in-Test logic for fault isolation
• VMEbus compatible (ANSI/IEEE STD 1014-1987 IEC 821 and 297)
• A24:A16:D32/D16/D08 (EO): slave 39/3D:29/2D:6U form factor
• Optional pull-up resistors for electronic switch outputs
• Front panel with fail LED
• Sockets are provided for warming resistors, which are supplied by the user
FUNCTIONAL CHARACTERISTICS
Compliance: This product complies with the VMEbus
specification (ANSI/IEEE STD 1014-1987 IEC 821 and
297) with the following mnemonics:
A24:A16:D32/D16/D08 (EO): Slave: 39/3D:29/2D:6U
form factor
Output Connector Type: Two 96-pin female
connectors are used with this board. For mass
terminations (IDC), an ERNI IDC DIN connector and
0.033-inch 30 AWG ribbon cable are recommended. The
ERNI order numbers are:
96-pin connector 913 031
96-conductor 0.033-inch cable 913 049
For discrete wire use, Harting connectors are
recommended. This connector consists of a contact
housing with female crimp-on contacts. Harting order
numbers are:
96-pin connector 09 03 096 3214
Female crimp-on contacts 09 02 000 8484
Crimp tool (for stripped wire) 09 99 000 0075
The discrete wire connector needs a shell housing that
has holding levers. We recommend the Harting housing.
Its order number is 09 03 096 0501. This housing will
latch the discrete wire cable to the board connector and
provide a strain relief.
I/O Organization: Sixteen output ports, eight bits wide
for a total of 128 inputs, addressable to any address
within the short supervisory and/or short nonprivileged
or the standard supervisory and/or standard
nonprivileged I/O map.
Addressing Scheme: Thirty-two bytes individually
addressable on 8-, 16-, or 32-bit boundaries. A Board ID
Register is located at the base address of the board. A
Control and Status Register (CSR) is stacked above the

GJR5251000R0202
GJR5251000R0101
GJR5250500R0902
GJR5250500R0262
GJR5250500R0202
GJR5250500R0101
GJR5250000R0303
GJR5250000R0252
GJR5250000R0202
GJR5250000R0151
GJR5250000R0101
FPR3600228R1202
FPR360227R1202
FPR3600227R0206
FPR3600201R1202
DSRF180A
DSRF160
DSRF150
DSRF160M