Vibro-meter 200-566-000-012 200-566-101-012 VM600 IOCN

Description

Vibro-meter 200-566-000-012 200-566-101-012 VM600 IOCN
VM600 (first generation)
ABE056 VM600Mk2/VM600 slimline rack : Refer to corresponding data sheet
AMC8 and IOC8T VM600 analog monitoring card pair : Refer to corresponding data sheet
ASPS VM600Mk2/VM600 auxiliary sensor power
supply
: Refer to corresponding data sheet
CPUM and IOCN VM600 modular CPU card and
input/output card.
Note: With a front-panel display and support
for Modbus RTU/TCP or PROFINET.
: Refer to corresponding data sheet
CPUR and IOCR VM600 rack controller and communications
interface card pair.
Note: With rack controller redundancy and
support for Modbus RTU/TCP.
: Refer to corresponding data sheet
CPUR2 and IOCR2 VM600 rack controller and communications
interface card pair.
Note: With mathematical processing of
fieldbus data and support for Modbus TCP
and PROFIBUS.
: Refer to corresponding data sheet
IRC4 VM600 intelligent relay card : Refer to corresponding data sheet
MPC4 and IOC4T VM600 machinery protection card pair : Refer to corresponding data sheets
RLC16 VM600 relay card : Refer to corresponding data sheet
RPS6U VM600Mk2/VM600 rack power supplies : Refer to corresponding data sheet
XMx16 + XIO16T VM600Mk2/VM600 condition monitoring
modules

In an ordering number (PNR), “h” represents the hardware version.
The standard version of the VM600Mk2 ABE040 system rack (PNR 204-040-100-016) and the standard version of the VM600Mk2/VM600
ABE040 system rack (PNR 204-040-100-015 or earlier) are the same, except for the specific artwork/branding/finish. More specifically,
the mounting brackets on the side of the ABE040 system rack are bare aluminium for the VM600Mk2 versions and painted for the
VM600Mk2/VM600 versions. See also Ordering guidelines on page 9.
For safety reasons, any VM600Mk2/VM600 ABE04x system rack slot not populated by a module (card) must be covered by a blank
panel(s).
(The width of a 19″ rack is typically measured in horizontal pitch (HP) units of 5.08 mm (0.2″), also known as standard width (TE) units.
For the VM600Mk2/VM600 ABE04x System racks, a 1 × slot wide blank panel suitable for covering one module (card) position
corresponds to 4 HP (TE), a 2 × slots wide blank panel corresponds to 8 HP (TE), a 3 × slots wide blank panel corresponds to 12 HP (TE)
and so on.)
When only one RPS6U power supply is installed in a VM600Mk2/VM600 ABE04x system rack (PS1 in rack slots 18 to 20), the unused
power supply position (PS2 in rack slots 15 to 17) should be populated with a blank panel(s).